RDS A100 Manual de Serviço descarregar pdf (Página 21)

E140

Unable to transfer data to print cartridges.

1: Print cartridge status information, as

under E127

2: Consumable protection status

information, as under E127

Contact problems / ink cartridge error / swapped cartridges

=>C: insert Inkjet cartridges again, replace ink cartridges

=>T: check contact properties in service mode

bad CP-Chip aplikation, PBD clean, check, exchange

E141

Unable to detect label properly. =>C: check labels, eliminate label jam (remove label dispenser subject, unlock letter transport (please

refer to section removing letter jams of ultimail operator manual))

Use FP Label only!

=>T: sw update 03.01.02 and higher more details TI 17a. Because the lable handling becomes

modified.

E142

Unable to calibrate label dispenser

sensor.

Sensor could not be calibrated - a label covers it =>

=>C: if necessary remove label from label passage, switch ultimail off and on again

E143

Unable to read data from print cartridges.

Contact problems / ink cartridge error / swapped cartridges

=> C: insert Inkjet cartridges again, replace ink cartridges

=> T: SW update min.: 02.39.07

E144

Print voltage has fallen to an

unacceptable value.

Polyswitch has triggered. Short circuit or to high current load to the or on the PenDriverBoard

=>T: Check PDB, PDB cable, and mainboard

E146

Errors occurred during printing process.

Subcode 1:cartridge-statusinformation

subcode

Contact problems / ink cartridge error / swapped cartridges

=> C: insert Inkjet cartridges again, replace ink cartridges

=> T: PDB's check, clean, change

run contact test in service mode

print voltage to low/high it is not s cartridge problem

see E146

diagnostic-

code

subcode1

subcode2

diagnostic message remedy

ISS international service support

email: [email protected] created : 20.11.2007 19:33 Uhr

page 21 Ultimail

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Ultimail 1

Comentários a estes Manuais

Sem comentários

RDS A100 Manual de Serviço Página 21

Comentários a estes Manuais