E132
The sealer drive is not running.
Microswitch of sealer is not toggled correct
=> C: release roller transport of sealer and close it again
E133
The feeder drive is not running.
Microswitch of sealer is not toggled correct
=>C: release roller transport of sealer and close it again
Feeder Power connection unpluged?
E134
Print cartridges not recognized.
Subcode 1: Print cartridge status
information
Subcode 2: Consumable protection status
information, as under E127
Eventually contact problems
=> C: insert Inkjet cartridges again
E135
Unknown print cartridges detected.
Contact problems / ink cartridge error / swapped cartridges => C: insert Inkjet cartridges again, replace
ink cartridges / E: check contact properties in service mode
E136
The print cartridges are not configured.
1: Print cartridge status information, as
under E127
2: Consumable protection status
information, as under E127
contact problems/ cartridge error/ mymail cartridge?
=> C: exchange cartridges
T: run contact test in Service mode
E137
Print cartridges are empty.
1: Print cartridge status information, as
under E127
2: Consumable protection status
information, as under E127
=>C: rplace cartridges again, repeat calibration
E138
Error E138 is an error in LS2 and LS3
timing.
Subcode 1: 0028 LS2 has closed, although LS1 has not yet closed (ErrNoLS1BeforeLS2)
Subcode 1: 000F Interval LS2_Close LS3_Close too small (less than 500 encoder pulses)
Subcode 1: 0010 Interval LS2_Close LS3_Close too large (more than 750 encoder pulses)
Subcode 2: Interval LS2_Close LS3_Close in encoder pulses
Example: E138, Subcode 1 000F, Subcode 01D0
Interval LS2_Close LS3_Close too small
Causes: LS2 closed slowly or no encoder pulses (dirty encoder)!
Letters are too short or too long / sensor error
=>C: use specified letters, feed letter again
E139
Communication error to print cartridges or
print process incorrectly performed.
1: Print cartridge status information, as
under E127
2: Consumable protection status
Contact problems / ink cartridge error / swapped cartridges
=>C: insert Inkjet cartridges again, changee ink cartridges
E: check contact properties in service mode
diagnostic-
code
subcode1
subcode2
diagnostic message remedy
ISS international service support
page 20 Ultimail
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais